Diemaking Supplies – Lead Edge Protector

Lead Edge Protector

Developed for the leading edge of rotary dies! Position the edge protector on the dieboard so it is flush against the side of steel rule. It deflects paper or board being cut by the rule, preventing jamming.

When corrugated material slivers off, it tends to pack between the rule and the dieboard causing board to break. By using our Lead Edge Protector as a buttress against the steel rule, you prevent this compaction! It resists fracturing at cold and hot temperature extremes. Available in 500ft. coils.

Lead Edge Guards

Available in two different sizes, small and jumbo. Packs of 100 pieces.